GRS Bench Mate Accessories

GRS Bench Mate Accessories

  • ID Ring Holder Set
    Quick view

    ID Ring Holder Set

    The new GRS ID Ring Holder takes ring fixtures to a new level. The expansion cones assure equal pressure on both sides of the mandrel as it grips the inside diameter of the ring.When using the Standard Cone, the ring drag can be set to allow smooth...

    $116.75
    Add to Cart
  • Inside Ring Holder
    Quick view

    Inside Ring Holder

    These fixtures securely hold rings from the inside, giving easy access for stone setting and ring engraving. Use in any GRS block and most vises. Both include holder body, seven collets, expansion cone, screws, and wrench.  

    $94.75
    Add to Cart
  • Inside Ring Mandrel
    Quick view

    Inside Ring Mandrel

    Includes holder body, 7 collets, expansion screw and wrench. Many wide, delicate or unusual rings are difficult to hold with an outside clamp. This attachment adds inside ring-holding capability to any BenchMate.It gives 200% more access to the outside...

    $132.00
    Add to Cart
  • Large Block Shelf & Adjustable Height Bracket Kit
    Quick view

    Large Block Shelf & Adjustable Height Bracket Kit

    This shelf uses the GRS BenchMate fixed mounting plate to hold your engraving block below the front of your bench. Jewelers especially like this because the top of their block is the same height as their bench pin.The Standard Shelf, used mainly with the...

    $132.75
    Add to Cart
  • 520 Attachment Set
    Quick view

    520 Attachment Set

    Includes 8 small pins, 4 flat square pins, 2 rectangular inset-curve pins, 4 thick round inset pins, 8 rubber coated pins, and 2 leather-faced ring clamp pins in molded base. With a variety of pins that fit the upper jaw plates of every GRS Block, you...

    $150.00
    Add to Cart
Compare Selected